These unique metal lathe tool accessories will allow the home shop machinist, model builder, gunsmith etc. to be able to utilize their Dremel®  tool, (or other moto-tool with either a 3/4 X 16 or 3/4 X 12 tpi thread, PLEASE SPECIFY THREAD SIZE UPON CHECKOUT!), on their metal lathe and be able to precisely control it's movement!

Made from either 1/2 inch high strength aluminum alloy, (DTH-01/375 round shank), or steel plate, (all others), tapped either 3/4 X 16 tpi or 3/4 X 12 tpi, (check the thread of your Dremel® ,  most are 3/4 X 12 tpi except the 370/380 series!) By placing the shank of this tool in your QC toolholder, you will be able to use your Dremel® tool as a cut-off tool to very precisley cut your bolts, screws to length! Great for the pen turner who wants to trim the brass inner tube or make his own tubes from bulk tubing! Precise grinding can be achieved by using the many sizes and profiles of grinding stones, discs etc. on the market while in your lathe's compound. Placing off-center holes in your projects while held in your lathe's chuck and using a drill bit in the moto-tool is easier than moving it to the drill press and having to do a set up again!

Use on any lathe with the appropriate sized tool holder to fit the model Dremel tool holder you purchased.

Models available...(either 3/4 X 12 OR 3/4 X 16 tpi)

     DTH-01..........1/2" X 1/2" shank...................................................$16.99

     DTH-.375.......3/8" ROUND shank, (3/8" boring bar holders)...$24.99

     DTH-.25.........1/4"H X 1/2"W shank............................................$16.99

NEW! DTH-.25OS...."offset" 1/4"H X 1/2"W shank......................$16.99

ALL MODELS AVAILABLE IN AN UNFINISHED STATE.........$10.00 

YOU DEBURR/DRILL 21/32 OR 11/16, (PILOT HOLE ALREADY CUT), TAP AS NEEDED AND COUNTERBORE. Full simple instruction sheet supplied!

SELECT MODEL #DTH-UNF on purchase page in "metalworking" and state which shank size/style you would like.NOTICE, THE 1/2 IN SHANK UNFINISHED MODEL IS NOW MADE FROM A HIGH STRENGTH ALUMINUM ALLOY! VERY EASY TO MACHINE.

DTH-.25OS - For fixed tool holders where top of shank will be on your lathes axis