"A-LEE-SAM"

#OT-1S only $38.99!

 For those interested in making their own ornamental Rose engine lathe from the various plans on the internet, this pre-made spindle will help you along! It is made from "turned & ground" 1 inch OD steel, (.997 actual +/- .001), 14 inches long. One end is threaded 1 X 8 threads per inch. NOW, with only about 1 inch of thread beyond shoulder and much finer threads using new stock material! The other end has a 2 inch long flat milled on the side to aid in holding a set screw. This version has a milled-while-on-spindle, (for accuracy), removable shoulder to tighten your chuck or faceplate up against. This shoulder NOW incorporates "flats" to enable easier chuck removal!

No need to find a local machinist to  custom make one for you,  (one customer told us he was quoted over $100 to make the same spindle)! We also carry the flanged bronze bearings for this spindle and for 3/4" shafts on our "purchase" pages.

OR

#DCB-01 only $29.99!

This pre-made spindled chuck backplate will help you along too! It is made from 12L steel and is 1 1/2 inches long. Spindle end is threaded 1 X 8 threads per inch, (1 inch of threads). The 2 inch diameter X 1/2 inch thick backplate is drilled and countersunk for 3 #8 woodscrews, (not included). Attach this to any material that can accept wood screws successfully and screw on your chuck, faceplate or a spindle mounted Jacobs drill chuck! Great for offset turning!