This pre-made spindle will help you along! It is made from polished 1 inch OD steel 14 inches long. One end is threaded 1 X 8 threads per inch. NOW, with only about 1 inch of thread beyond shoulder! The other end has a 2 inch long flat milled on the side to aid in holding a set screw. This version has a milled-while-on-spindle, (for accuracy), removeable shoulder to tighten your chuck or faceplate up against. This shoulder NOW incorporates "flats" to enable easier chuck removal!
Alisam Engineering, PO Box 75, Lima, New York 14485 ©Alisam Engineering 2008
Order Status