These
unique metal lathe tool accessories will allow the home
shop machinist, model builder, gunsmith, etc . to be able
to utilize their Dremel® tool (or other moto-tool with either
a 3/4 X 16 or 3/4 X12 tpi thread) on their metal lathe and
be able to precisely control its movement!
Made
from 1/2" high strength aluminum alloy, tapped either
3/4 X 16 tpi or 3/4 x 12 tpi (check the thread of your Dremel®
- most art 3/4 X 12 tpi except the 270/370/380 series).
By
placing the shank of this tool in your QC toolholder, you
will be able to use your Dremel® tool as a cut-off tool to
very precisely cut your bolts/screws to length.
Great
for the pen turner who wants to trim the brass inner tube
or make his own tubes from bulk tubing. Precise grinding
can be achieved by using the many sizes and profiles of
grinding stones, discs, etc. on the market while in your
lathe's compound. Placing off-center holes in your projects
while held in your lathe's chuck and using a drill bit in
the moto-tool is easier than moving it to the drill press
and having to do a set up again.
Use
on any lathe with the appropriate sized tool holder to fit
the model Dremel® tool holder you purchased.
